ASX24-Crawler

ASX24-Crawler

39,95 EUR

excl. Shipping costs

Shipping time: 3-4 days*


Bewertung schreiben


Completely new development especially for small crawlers. Even smaller, even lighter, extremely sensitive software! Full torque even in the lower speed ranges perfect for climbing. This version of the controller is supplied with open wire ends. Connectors for the motor and battery must be fitted by the customer himself as required. A plug and play version for SCX24 models is in the works and will be available when the appropriate plugs arrive. Cable to the receiver is of course installed.

This controller is designed exclusively for brushed motors, it will not work with BL motors.

Features:
  • Setup function. The controller is delivered pre-set so that it works the same with all standard RC systems. For special RC systems or for fine tuning, the controller can be set exactly to each system using the setup function.
  • 5-9 cells / 2-3 S Lipo ( Limited to 3.3V per cell when Lipo monitoring is switched on)
  • Automatic cell number detection in Lipo mode (at approx. 3.3 volts per cell, the maximum output is limited to 25% and the controller signals that the battery is empty by jerking the motor. Driving back is still possible) Lipo mode can be switched on / off
  • Current max 8 A continuous; 10A momentarily BEC to 9 cells / 3s Lipo. 2A / 5V
  • 50% reversing limitation adjustable via setup Delivery condition 100% forwards / backwards
  • Overtemperature monitoring, if the controller gets too hot, it regulates back to max. 25% power.
  • Full HF 18 kHz output stage over the entire control range, NO motor whistling and extremely sensitive control
  • Motor-friendly polarity reversal through speed-dependent polarity reversal time with brake. (In the lower speed range, the polarity is reversed immediately. At high speeds, the controller brakes the motor beforehand, so that the batteries and motor are protected from high current peaks.)
  • Handbrake function. When the throttle lever is at 0, the vehicle is braked, then the handbrake is pulled.
  • Engine acknowledgment (connect to the battery for setting in setup mode and for the OK message)
  • Start-up protection (The controller only goes into operation when the throttle stick is set to 0. This rules out accidental start-up of the motor) If there is no RC signal, the vehicle stops.
  • Super-sensitive control behavior (high direct 10-bit evaluation system)
  • 0.5 mm˛ highly flexible connection cable with silicone sheath
  • Dimensions 21 x 25 x 5mm Weight 9 g weighed with cable.
  • Of course quality "Made in Germany"
  • You can find the instructions in the download area of ​​our homepage

            The 1 EUR piece shown in the picture is used to show the size of the product and is not included in the scope of delivery.

Customer reviews:

Author: Daniel S. am 04/05/2022
Evaluation:5 of 5 Stars!

Review:

Awesome ESC, the best you can get for your 1/24 or 1/18 crawler. Silent, smooth and quality equal to none. Get one before they run out of stock (again)!

This Product was added to our catalogue on 07/03/2022.

  Shopping cart

You do not have any products in your shopping cart yet.

Reviews

ASX24-Crawler
Awesome ESC, the best you can get for your 1/24 or 1/18 craw
5 of 5 stars!