Special offer only available while stocks last.
The new AS12/15RW Lipo + matching 600 motor.
Attention, the motor included in this set is B-stock because the metal ring is not 100% optical. You can also see small stains on the ring in the picture. The engine itself is optically and technically flawless, even very high quality. If it doesn't bother you visually, you can use the engine as it is. But you can also make the metal ring nice with a bit of sandpaper. Because of the defects in the motor, the set is only EUR 3.05 more expensive than the controller alone. The set works great with 3S Lipo or 12 volt lead.
Technical data on the engine:
1 to 1 interchangeable with 500/600 motors from Graupner and similar. ( Fits in the same holder )
Shaft 3.15 + 6mm flattened.
Idle about 8000 revs on 3S Lipo or 12 volt lead (Under suitable load 6000)
Very high torque (5 pole armature)
Maximum allowable current 8 amps
For displacement and semi-sliding engines up to a screw size of about 35 mm at 12 volts
No preferred direction of rotation, the motor rotates equally fast in both directions.
The engine shows its inner values through quiver carbons (cheap engines have so-called hammer carbons)
Technical data for the controller:
The new AS12/15RW-LiPo is delivered pre-programmed. Setting the zero and full throttle points is not necessary with all standard systems that are available for purchase. Simply plug in and off you go. The lipo function can be switched on and off with just one push of a button on the controller. There is also a setup function for special RC systems or particularly old models.
Small front/back controller for scale models
Suitable e.g. for Dunker, Bühler or small speed motors, in smaller models
This controller is designed exclusively for brushed motors, it is not suitable for BL motors.
Features:
5-12 cells NiCd NiMh / 6 or 12 volt lead / 2-3 S Lipo with automatic cell count detection and undervoltage protection.
Lipo undervoltage protection. At around 3.3 volts per cell, the maximum output is limited to 25% and the controller gives stuttering gas only short, fast gas impulses. That way you know it's time to go in)
Optical control of the lipo mode .... the controller shows via LED whether the lipo protection is active.
15 A continuous; 20A momentarily
Synchronous output stage for full power when driving forwards and backwards
High-performance BEC up to 12 cells / 2 A max
optional power limitation when reversing programmable to 50%
Silent driving with high switching frequency (18KHz) over the entire speed range. The regulation of the engine is completely silent, there are no engine whistles and whistles. Only the mechanical noises of the drive can be heard.
Fast motor-friendly polarity reversal: When reversing the polarity from forward to reverse, the controller automatically brakes the motor as quickly as possible and then immediately accelerates it in the opposite direction. This controller does NOT have a proportional brake as is usual with RC car controllers. The full stick travel is therefore available for proportional forward and reverse control. As a result, there are hardly any noticeable polarity reversal delays close to the zero point. The fastest motor reversal is therefore possible.
Perfect failsafe (receiver signal is constantly checked) LED indicates when the received signal is lost
Engine acknowledgment (connect to the battery for the setup function and for the OK messages)
Start-up protection (The controller only goes into operation when the throttle stick is set to 0. This prevents the motor from starting up accidentally)
Super-sensitive control behavior 10-bit resolution. The standard is 8 bits for the vast majority of commercially available controllers. As a result, the motor can be controlled extremely sensitively. The resolution of the control is therefore higher by a factor of 4.
Protection against splashing water thanks to protective coating and shrink tubing.
1 mm² highly flexible connection cable
Dimensions 31 x 26 x 7mm
Weight about 20g
Of course quality "Made in Germany"
This Product was added to our catalogue on 27/03/2023.
